Weather Pack Connector Assembly

1.) Install correct seal onto wire before stripping insulation. (observe for proper direction of seal) (fig.1&2)

2.) Crimp or solder terminal onto stripped wire. Slide seal down to terminal and crimp in place. (fig.3) Open connector body, insert terminal into connector housing.

3.) Once all terminals are crimped and inserted, close connector bodies to lock in wire and seals.

This example was soldered

Female Housing Male Housing
Seal Selection Chart Seal Wire Type and Gauge
Green 18-16 18 18-16 16-14
Gray 14 16 14 12
Blue 12 14-12 12 10

Weather Pack Connector Kits Weather Pack Replacement Pins Weather Pack Wire Seals Weather Pack Pin Removal Tool