Battery Power Accessories

Battery Compression Ends
Pre-Soldered Battery Ends
Copper Lugs
Military Battery Connectors
Battery Cable Heat Shrink
Battery Cable & Wire
Anti Corrosion Washers
Side Terminal Battery Tap
Mil Spec Batt Terminal Kit

Master Disconnect Switch
Neg. Post Disconnect
Battery Quick Disconnect Kit
Keyed Battery Switch

Continuous Duty Solenoids
Remote Starter Solenoid

Terminal Covers
Battery Junction Blocks
Ground Strap
Battery Jumper Terminals
Remote Battery Terminals
Battery Mat

Continuous Duty Solenoids

(case gnd)


Use for switching any high current application or solution for battery isolation in dual battery configurations. Rated for 12 Volt 85 Amp. 5/16" studs on input and output. (Includes Wiring Diagram).
High Power Solenoid


Use for battery switching or other applications that require high current demand. This continuous duty solenoid is for 12 volt applications an is rated for 200 amps. Features isolated ground case 4 wire design with 5/16" input/output studs.

Remote Battery Disconnect Diagram

Continuous Severe Duty Solenoid


Our highest rated continuous duty solenoid at 225 Amps. This heavy duty solenoid can be used in many HD applications including, battery disconnect, alternator shut down and battery isolator. 12VDC

Latching Solenoid


Continuous duty solenoid uses a latching coil. Apply 12V to the coil through a momentary push button to turn solenoid ON or OFF. Due to the latching operation, solenoid will not heat up or drain battery when in use. Great for a battery disconnect switch or battery isolator. 12VDC Rated 110Amps

See Push Button Disconnect Diagram